Insert the bootable disk into floppy drive and press Enter. Select Enabled to support compliance with PCI specification. Overclock Panel Click the Overclock button in Main Panel, the button will be highlighted and the Overclock Panel will slide out to left as the following figure. In this case, please double check: It will disable the output on back panel audio connectors. On default , Off. Disabled default , 2 bank, 4 bank.
|Date Added:||11 September 2007|
|File Size:||69.47 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Re-install applications and data using backup disks. Indicator light on key board does not turn on. The Setup program allows users to modify the m7vix system configuration. T his equipment generatesuses and can radiate radio frequency energy and, if not ins talled and used in accordance with the instructionsmay cause harmful interference to radio communications. Make sure both ends are securely plugged in; check the driv e type in the standard CMOS setup.
Onboard Serial Port 2 Select an address and corresponding interrupt for the first and second serial ports. Then system will do fail-safe reboot by using Watchdog function. Ref ormat the hard driv e.
When connecting with wires onto connectors, please note that the red wire is the positiv e and should be connected to pin 2, and the black wire is Ground and should be connected to GND. It supports 3 pin head connector.
Item Options Date mm: All the CMOS data will be loaded as defaults setting. Disabling this option reduces the time it takes to boot-up. All m7ivz disks are capable of breaking down at any time. The item offers several delay time for you to choose.
When this area is reserved, it cannot be cached. Auto defaultDisabled. Backing up the hard drive is extremely important. The deeper the depth is, DRAM Command Rate This item controls clock cycle that must occur between the last valid write operation and the next command.
Wait for five seconds. Disabled defaultenable.
Setup default A password is required to access the Setup Utility only. DPMS Initial display power management signaling.
Hardware Monitor Panel Click the Hardware Monitor button in Main Panel, the button will be highlighted and the Hardware Monitor panel will slide out to left as the following figure. Every peripheral device has a node, which is called ESCD.
However, the color information coming from the VGA controller is drawn from the palette table inside the VGA controller to generate the proper colors, and the graphic controller needs to know what is in the palette of the VGA controller. Disabled default15M — 16M.
Main Panel contains fe ature s as follows: You will be prompted with audlo enter a password. Execute the setup execution file, and then the following dialog will pop up.
Overclock Panel Click the Overclock button in Main Panel, the button will be highlighted and auddio Overclock Panel will slide out to left as the following figure.
Bank Interleave This item allows you to enable or disable the bank interleave feature. Non-OS2 defaultOS2. Video Off Method This option determines the manner in which the monitor is goes blank. ATX power source K.
A confirmation message will be displayed before defaults are set. This completes the installation.