ARGOX X 2000V PPLB DRIVER

0 Comment

Before calibration, be sure media and ribbon for thermal transfer printing have been loaded correctly. Figure 3 3 Dispenser Module Peel Lever 25 4. Select the port of the printer and click “Next”. Courier font with different symbol sets. The adjusting steps are as follows: If the test print appears as Figure B, remain the screw at the left of Ribbon Bracket fixed, and then loose the screw at the right, and gradually fine-tune upward, until the print quality gets improved.

Uploader: Gazragore
Date Added: 26 December 2006
File Size: 63.1 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 45382
Price: Free* [*Free Regsitration Required]

Check if the printer power is turned on.

Argox X |

Select next function setting. Pin assignments are as follows: Buttons There are three buttons, each with two basic functions. Turn off the printer; disconnect the AC power cable.

Make sure the coating side of the ribbon is face down. The FEED button does not make the printer peel. X series printers use ribbon wound ink-side in as default. It decides which setting method pplbb by command or by LCD panel, is prior.

Refer to the following examples. Clockwise rotate the screw a half circle and test printing; observe whether the printing quality has been gradually improved or not; and stop the adjustment if the quality is improved. Cutter mode automatically cuts the label after it prints. After the related files have been copied to your system, click “Finish”.

New Drivers  HUAWEI FWT MODEM DRIVER DOWNLOAD

Seagull Argox X-2000v PPLB Free Driver Download (Official)

If the test print appears as Figure B, remain the 2000vv at the left of Ribbon Bracket fixed, and then loose the screw at the right, and gradually fine-tune upward, until the print quality gets improved.

If there are any items missing, please contact your local dealer.

Hold both buttons for about 3 seconds and release. Check the Cam as marked in Figure 1, find a slotted screwdriver to turn counter-clockwise as Figure 2.

Manual calibration is needed. Repeat Step 1; if the printing polb has not been gradually improved after five times, counterclockwise rotate five circles back to the original position and then proceed Step 3. Close the peeler module using the peel-off mechanism release lever. Check all the data on the showing screen, if it is correct, click “Finish”.

Argox X Industrial Label Printer.

It also badly handles the situation where a printer driver is already in use by a Windows application. Send the file, KBD. Lead the media backing paper through the print head module.

New Drivers  DELL WIRELESS 5720 VZW MOBILE BROADBAND DRIVER

Clean the print head as follows: If problem continues perform a label sensor calibration. Centronics allows a much higher communication speed than serial. Figure 1 Figure 2 93 Guillotine Cutter with Paper Jam If there is paper jam inside guillotine cutter, check in Figure 1 and find where the screw under guillotine cutter.

Cleaning the Roller Using a cotton bud moistened with alcohol, clean the roll and remove any attached glue. The screens included arogx these steps are taken from Windows XP; steps in other versions of operation systems are similar. The emulation is a printer programming language through which the host can communicate with your printer.

Windows Vista, Windows 7, Windows 8 and 8. Make a form for barcode reader. Turn the pick-up spindle to ensure the ribbon is tightly wound.

Programmable by command Data format: Related questions Dear Sir, Can i connect directly to Argox ppla printer using php? Push down the peel-off mechanism release lever and lead the media under the peeler module.