Join thousands of tech enthusiasts and participate. With one drive, you don’t want it set for RAID. CD player and video fail. The board works fine, my complaint is about missing parts. If you need to reset your password, click here.
|Date Added:||26 September 2013|
|File Size:||57.19 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
What floppy or what CD in particular? Introduction to Linux – A Hands on Guide This guide was created as rai overview of the Linux Operating System, geared toward new users as an exploration tour and getting started guide, with exercises at the end of each chapter.
I’d prefer to do eaid fresh install rather than bring over all the trash I have the registry. I’ll post more tomorrow after I have a chance to babysit with the install My 4 logical drives 1 physical and my DVD. Most Active Forum Topics this week The board I ordered on ebay arrived on time, well packed and in great condition.
I have never updated a bios. Note that registered members see fewer ads, and ContentLink is completely disabled once you log in.
Before you can use Windows Updatesthe system must already have Service Pack 3 installed. Please elaborate on the circumstance in which the “drive is still not seen”. I see the new option for raid or scsi, I have that enabled.
If you did not receive our reply. I have two drives at gb. Posted 24 September – So in the bios you should have 2 different options for SATA mode. Leave memory frequency at SPD.
Only way to restart the PC is to turn the PS off on the back or remove the power plug I will try to report the error messages in another post, because I am unable to copy and paste the boot-up messages here. Have you also used the sil setup utility ie F4 on startup to set the raid up and what type of raid are you trying to set up stripe or mirror.? Widespread Centurylink Outage this morning Complete power down at the same point when trying to load window to USB drive.
Not having done this before, I am not sure what it will see. Already have an account? Any thoughts on that? I am not sure it sees both drives. I have installed a ide drive and loaded windows on. I do believe it is being reconized now.
I tend to use tools from driverpacks. Yes, I have updated my bios, and now have it set to boot to Raid. No message to put a floppy or CD in no matter what my boot sequence is. Click Here to receive this Complete Guide absolutely free. Now that I can, it has become “old” technology, relatively speaking.
I can get to the prompt indicating no previous version of windows is found rather than no drive found.
The attached rajd shows an example of a connector bezel not the correct one for this motherboard. The problem is that while booting Linux the devices hde hdg are trying to get detected and takes a long time to boot.
Fire up the computer and go into BIOS setup.